Performance evaluation of an automatic load-haul dump vehicle

Cette publication n'est pas offerte dans votre langue; certains de ses renseignements ont été préremplis pour la version française.
Mots clés : Underground mining;Equipment evaluation
Accés complet à Document technique
Version PDF pour 20,00 $
Recherche
Trier par :  Pertinence
Affichage des résultats 1 - 5
Texte
Publication: CIM Bulletin
Auteur(s): P.M. Tiley, W.G. Spencer, E. Sulis
Mots clés: Equipment, Hoisting systems, Dome Mine.
Numéro: 974
Volume: 86
Année: 1993
Texte
Publication: CIM Bulletin
Auteur(s): A. Zaidi, S. Kumar
Mots clés: Natural gas, Technology, Cogeneration systems, Energy efficiency, NOX emissions.
Numéro: 974
Volume: 86
Année: 1993
Texte
Sommaire: This article addresses the relationship between mine evaluation, the tax system, and economic risk. It is based on a paper presented by the author at recent seminars in Moscow and Tashkent on the subject of mine evaluation.
Publication: CIM Bulletin
Auteur(s): Robert B. Parsons
Numéro: 974
Volume: 86
Année: 1993
Texte
Sommaire: At Dofasco's No. 4 furnace a variation of the basic oxygen steel-making process, Klockner Oxygen Bottom Maxhutte (K-OBM), is used to produce steel. Large amounts of hot gases and paniculate are evolved during the oxygen blowing phase. A quencher and a venturi scrubber are used to collect over 99.5 % of the paniculate. In 1990, the authors investigated the effect of foamy slag on the paniculate emissions from the furnace. The amount of lime added early in the oxygen blowing cycle was reduced,...
Publication: CIM Bulletin
Auteur(s): E. Cocchiarella
Mots clés: Basic oxygen processes, Foamy slag, Particulates, Fume suppression, Waste BOF oxides.
Numéro: 974
Volume: 86
Année: 1993
Texte
Sommaire: Many of the ore bodies presently being developed are in remote locations and are, or will be, served by electrical power supply systems of limited capacity.The largest single components of the electrical systems of an underground mine are usually the production hoist drives; the power demands of these drives vary continuously throughout each hoisting cycle.
Before 1970 mine hoists were driven by either wound rotor induction motors or DC motors in conjunction with motor-generator sets.Static...
Publication: CIM Bulletin
Auteur(s): G.L. Tiley, B.C. Legg
Mots clés: Equipment, Hoisting systems, Electrical drives.
Numéro: 974
Volume: 86
Année: 1993
Activé par Coveo Enterprise Search